- NETWORK TECHNOLOGIES PS/2 KVM Switch Installation and Operation Manual KEEMUX-Px

ManualsBrandsNetwork Technologies ManualsSwitchKEEMUX-Px

NTI KEEMUX Series PS/2 KVM Switch

OSD Command Mode (Cont'd)

Function: Keystroke:

Sets scan time-out on

each port

Selects a specific port

Enters Search Mode and adds a character

to search string and selects the CPU’s

name that matches best.

Selects the first port on the switch

Selects the last port on the switch

Switch to a selected port

Exit OSD Command Mode

The mouse can also be used to control Command Mode. The mouse

cursor can be moved to the Scan, Help, and Exit fields where the user

can then click on the left mouse button to perform that function. Ports

listed on the screen can be selected by moving the cursor onto that port

and clicking. Clicking twice on a selected port will switch to that port

and exit Command Mode. To change the displayed ports on the screen

simply click on the up and down arrows located to the right of the port

names displayed.

Figure 10- Press <Ctrl> for more functions

Scan Mode

When in Scan Mode the switch scans to each port with a CPU powered-ON. (The SCAN LED on the front panel will illuminate and

remain ON while in Scan Mode.) To enter Scan Mode press <Ctrl> + <S> from Command Mode. The port with the CPU

powered-ON remains active while in use. When the switch becomes idle for the configured time-out period (default time-out

period is 5 seconds) the switch will connect to the next powered-ON CPU port. See Command Mode section above for configuring

the scan time-out period.

NOTE: The keyboard and mouse must remain idle for the full scan time-out period before the switch will connect to the

next active port.

(xxx from 002 to 255. ie. t002

would set the time-out period

for 2 seconds)

(0-2)

(0-9)

Ctrl

Enter

A-Z

0-9

(Type any alphabetical or numeric character)

Esc

(Pxx would be P01, P02, etc.)

(0-9)

Ctrl

Note: The user must exit

Command Mode to type to a CPU.

To exit Command Mode, either

hold down any touch-switch on the

front panel for more than 2

seconds, OR press <ESC>.

Home

End