PRIMUX® Series PRIMUX-16X64 PRIMUX-8X32 KVM Matrix Switch via CATx Quick Start Guide PRIMUX-16X64 (Front and Rear View) PRIMUX-UZR User Station (sold separately) 1 HA-UNV PS/2 and USB Host Adapter (sold separately)
What's in the Box Terminating Plug NTI PRIMUX-16X64 or 8X32 Cat5 KVM Matrix Switch AC Line Cord Country Specific Manual CD Quick Start Guide What's also needed (sold separately) • • • NTI Host Adapter(s) HA-UNV PS2/USB Host Adapter (Includes a CT7038 USB-PS2 Adapter)/ HA-SUN-MTX SUN Host Adapter / HA-RS-M Serial Host Adapter (see chart on page 7) NTI PRIMUX-UZR User Station CAT5/5e/6 unshielded twisted-pair cable(s) terminated with RJ45 connectors wired straight thru (pin 1 to pin 1, etc.
Hardware Setup 1. Disconnect power from each CPU to be connected. (If your CPU fully supports hot-plugging, powering-down will not be necessary). 2. Plug the appropriate Host Adapter into the devices and video ports on the back of each CPU.
Cable to CPU 3. Connect a CAT5 cable from the "OUT" port on each Host Adapter to a "CAT5" port on the PRIMUX KVM Matrix Switch. 4. Connect the Terminating Plug (supplied with Host Adapter) to the "IN" port on each Host Adapter. ! WARNING: Never connect the PRIMUX Host Adapter, User Station, or Matrix Switch to an Ethernet card, Ethernet router, hub or switch or other Ethernet RJ45 connector of an Ethernet device. Damage to devices connected to the Ethernet may result.
7. Connect a Cat5 cable between the “Cat5” port on the User Station and a “User” port on the Matrix Switch. Rear View of PRIMUX-Matrix Switch 32 31 30 29 28 27 26 CPU 25 24 23 22 21 20 19 18 17 7 USER 6 8 5 EXPANSION PORT ETHERNET RS232 16 14 15 13 12 11 9 10 CPU 8 6 7 5 3 4 2 4 1 3 USER 2 1 NTI R NETWORK TECHN OLOGIES INC Tel: 330-562-7070 1275 Dan ner Dr, Au ro ra, OH 44202 www.nti1.
Initial Startup Upon startup, the Command Mode On Screen Display (OSD) menu will be displayed, auto-logging you in as the administrative user “root”. By default, the user “root” has full administrative rights and access to all Host Adapters and their connected CPUs.
Make a Connection From the Command Mode menu, to make connection to any Host Adapter, press or to highlight and select the desired Host Adapter, press to connect to it. -ORuse the mouse to highlight the desired Host Adapter to connect to and left-click on it to connect. Press to exit Command Mode and use the connected CPU. Press + <`> to return to the Command Mode OSD menu. Congratulations, you have successfully installed your PRIMUX Matrix Switch.