User manual

Removing the shelf support rails
1
Pull the front of the
shelf support rail away
from the side wall.
2
Pull the rear shelf
support rail away from
the side wall and remove
it.
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must
point to the front.
Oven Ceiling
You can fold down the heating element on the oven
ceiling to clean the oven ceiling easily.
Folding down the heating element
1. Remove the shelf support rails.
2. Hold the heating element with the two hands at
the front
3. Pull it forwards against the spring pressure and
out along the support on both sides.
4. The heating element folds down.
The oven ceiling is ready to clean.
Installing the heating element
1. Install the heating element in opposite sequence.
Important! Install the heating element correctly on the
two sides above the support on the inner wall of the
oven.
2. Insert shelf support rails.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the door
from the appliance. The door is heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two door hinges
fully.
A
A
3. Close the oven door until the first position (angle
approx. 45°).
45°
4. Hold of the oven door with one hand on each
side and pull it away from the oven at an upwards
angle.
Put the oven door with the outer side down on a
soft and level surface to prevent scratches.
5. Now you can remove the inner glass panels and
clean them.
To install the door follow the procedure in re-
verse.
14