User manual

Installation
Warning! Refer to Safety chapters.
Location
Refer to the assembly instructions for the
installation.
To ensure best performance, install the appliance well
away from sources of heat such as radiators, boilers,
direct sunlight etc. Make sure that air can circulate
freely around the back of the cabinet.
Positioning
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance.
Climate
class
Ambient temperature
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be guaranteed
within the specified temperature range. If
you have any doubts regarding where to
install the appliance, please turn to the
vendor, to our customer service or to the
nearest Authorised Service Centre.
Electrical Connection
Caution! Any electrical work required to
install this appliance should be carried
out by a qualified electrician or
competent person.
Warning! This appliance must be
earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
The wires in the mains lead are coloured in accordance
with the following code:
A B
C
D
E
• A - green and yellow: Earth
• C - brown: Live
• D - blue: Neutral
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows:
1. Connect the wire coloured green and yellow to the
terminal marked either with the letter “E“ or by the
earth symbol
or coloured green and yellow.
2. Connect the wire coloured blue to the terminal
either marked with the letter “N“ or coloured black.
3. Connect the wire coloured brown to the terminal
either marked with the “L“ or coloured red.
4. Check that no cut, or stray strands of wire is
present and the cord clamp (E) is secure over the
outer sheath.
Make sure the electricity supply voltage is the same
as that indicated on the appliance rating plate.
5. Switch on the appliance.
The appliance is supplied with a 13 amp fuse (B). In the
event of having to change the fuse in the plug supplied,
a 13 amp ASTA approved (BS 1362) fuse must be
used.
Warning! A cut off plug inserted into a
13 amp socket is a serious safety
(shock) hazard. Ensure that it is
disposed of safely.
11