User manual

• Never try to extinguish a fire with water, but switch off the appliance and then
cover flame e.g. with a lid or a fire blanket.
• Do not store items on the cooking surfaces.
• Do not use a steam cleaner to clean the appliance.
• Metallic objects such as knives, forks, spoons and lids should not be placed
on the hob surface since they can get hot.
• If the glass ceramic surface is cracked, switch off the appliance to avoid the
possibility of electric shock.
Safety instructions
Installation
Warning! Only a qualified person must install this
appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied with the ap-
pliance.
• Keep the minimum distance from the other applian-
ces and units.
• Always be careful when you move the appliance be-
cause it is heavy. Always wear safety gloves.
• Seal the cut surfaces with a sealant to prevent mois-
ture to cause swelling.
• Protect the bottom of the appliance from steam and
moisture.
• Do not install the appliance adjacent to a door or un-
der a window. This prevents hot cookware to fall from
the appliance when the door or the window is
opened.
• If the appliance is installed above drawers make sure
that the space, between the bottom of the appliance
and the upper drawer, is sufficient for air circulation.
• The bottom of the appliance can get hot. Make sure
to install a non-combustile separation panel under
the appliance to prevent access to the bottom.
Electrical connection
Warning! Risk of fire and electrical shock.
• All electrical connections must be made by a quali-
fied electrician.
• The appliance must be earthed.
• Before carrying out any operation make sure that the
appliance is disconnected from the power supply.
• Use the correct electricity mains cable.
• Do not let the electricity mains cable tangle.
• Make sure the mains cable or plug (if applicable)
does not touch the hot appliance or hot cookware,
when you connect the appliance to the near sockets
• Make sure the appliance is installed correctly. Loose
and incorrect electricity mains cable or plug (if appli-
cable) can make the terminal become too hot.
• Make sure that a shock protection is installed.
• Use the strain relief clamp on cable.
• Make sure not to cause damage to the mains plug (if
applicable) or to the mains cable. Contact the Service
or an electrician to change a damaged mains cable.
• The electrical installation must have an isolation de-
vice which lets you disconnect the appliance from the
mains at all poles. The isolation device must have a
contact opening width of minimum 3 mm.
• Use only correct isolation devices: line protecting cut-
outs, fuses (screw type fuses removed from the hold-
er), earth leakage trips and contactors.
Use
Warning! Risk of injury, burns or electric shock.
• Remove all the packaging, labelling and protective
film (if applicable) before first use.
• Use this appliance in a household environment.
• Do not change the specification of this appliance.
3