EN User Manual Dishwasher IDSH604W
Contents Safety information Safety instructions Product description Control panel Programmes Settings Before first use 2 3 4 5 5 6 8 Daily use Hints and tips Care and cleaning Troubleshooting Technical information GREAT BRITAIN – Customer Care and Service 9 10 11 13 15 16 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
• • • • • • • • Obey the maximum number of 13 place settings. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Put the cutlery in the cutlery basket with the sharp ends pointing down or put them in the cutlery drawer in a horizontal position with the sharp edges down. Do not leave the appliance with the open door unattended to avoid stepping accidentally onto it.
• from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. Use • • • • • • Do not sit or stand on the open door. Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. Do not drink and play with the water in the appliance. Do not remove the dishes from the appliance until the programme is complete. Some detergent may remain on the dishes. The appliance can release hot steam if you open the door while a programme operates.
11 Upper basket Control panel 3 2 1 4 1 On/off button 2 Programme indicators 3 Indicators 4 Programme button Indicators Indicator Description End indicator. Salt indicator. It is always off while the programme operates. Programmes Programme 2) Degree of soil Type of load Programme phases Consumption values 1) Duration (min) Energy (kWh) Water (l) Normal soil Crockery and cutlery • • • • Prewash Wash 50 °C Rinses Dry 227 1.
Programme 3) 4) Degree of soil Type of load Programme phases Fresh soil Crockery and cutlery • • Wash 60 °C or 65 °C Rinses All • Prewash Consumption values 1) Duration (min) Energy (kWh) Water (l) 30 0.8 10 14 0.1 5 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values.
Water hardness German degrees (°dH) French degrees (°fH) mmol/l Clarke degrees Water softener level 47 - 50 84 - 90 8.4 - 9.0 58 - 63 10 43 - 46 76 - 83 7.6 - 8.3 53 - 57 9 37 - 42 65 - 75 6.5 - 7.5 46 - 52 8 29 - 36 51 - 64 5.1 - 6.4 36 - 45 7 23 - 28 40 - 50 4.0 - 5.0 28 - 35 6 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 2 <4 <7 <0.
How to deactivate AirDry The appliance must be in programme selection mode. 1. To enter the user mode, press and hold the programme button until the indicator 2. 3. flashes and indicators and are on. Press the programme button twice. • The indicators • The indicator Wait until the indicators The indicator • During the drying phase, the door opens automatically and remains ajar. Caution! Do not try to close the appliance door within 2 minutes after automatic opening.
Caution! Only use rinse aid specifically designed for dishwashers. 1. 2. 3. 5. Turn the cap of the salt container clockwise to close the salt container. Caution! Water and salt can come out of the salt container when you fill it. After you fill the salt container, immediately start a programme to prevent corrosion. 4. Press the release button (D) to open the lid (C). Pour the rinse aid in the dispenser (A) until the liquid reaches the fill level 'max'.
Using the multi-tablets When you use tablets, that contain salt and rinse aid, do not fill the salt container and the rinse aid dispenser. 1. 2. the programme duration. After closing the door, the appliance continues from the point of interruption. If the door is opened for more than 30 seconds during the drying phase, the running programme ends. It does not happen if the door is opened by AirDry function. Adjust the water softener to the lowest level. Set the rinse aid dispenser to the lowest position.
• • Detergent tablets do not fully dissolve with short programmes. To prevent detergent residues on the tableware, we recommend that you use the tablets with long programmes. Do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging. What to do if you want to stop using multi-tablets Before you start to use separately detergent, salt and rinse aid do the following procedure. 1. 2. 3. 4. 5. Set the highest level of the water softener.
7. 8. 2. 3. Remove the filter (C) out of filter (B). Remove the flat filter (A). 4. Wash the filters. Reassemble the filters (B) and (C). Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. Caution! An incorrect position of the filters can cause bad washing results and damage to the appliance. Cleaning the spray arms Do not remove the spray arms. If the holes in the spray arms are clogged, remove remaining parts of soil with a thin pointed object.
cleaning product for dishwashers. Follow carefully the instructions on the packaging of the product. Troubleshooting If the appliance does not start or it stops during operation, before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. With some problems the end indicator flashes intermittently indicating a malfunction.
Problem and alarm code Possible cause and solution Rattling/knocking sounds from inside the appliance. • The appliance trips the circuit-beaker. • • • The tableware is not properly arranged in the baskets. Refer to basket loading leaflet. Make sure that the spray arms can rotate freely. The amperage is insufficient to supply simultaneously all the appliances in use. Check the socket amperage and the capacity of the meter or turn off one of the appliances in use.
Problem Possible cause and solution The interior of the appliance is wet. • This is not a defect of the appliance. it is caused by the humidity in the air that condenses on the walls. Unusual foam during washing. • • Use the detergent for dishwashers only. There is a leak in the rinse aid dispenser. Contact an Authorised Service Centre. Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener".
Power consumption Left-on mode (W) 5.0 Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. GB GREAT BRITAIN – Customer Care and Service Standard Guarantee Conditions and Exclusions. All our products come with 12 month warranty.
156915390-A-092017
