User manual

6. Screw the water inlet hose back on and re-fit the
emergency emptying hose after having put the cap
on again.
Warning! Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
Emergency emptying out
If the appliance does not drain the water, proceed as
follows:
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. If necessary, wait until the water has cooled down.
4. Place a bowl on the floor and put the end of the
emergency emptying hose into the bowl. Remove
its cap.
The water should drain by gravity into the bowl.
5. When the bowl is full, put the cap back on the
emergency hose.
6. Empty the bowl. Repeat the procedure until water
stops flowing out.
7. Clean the pump if necessary as previously
described.
8. Replace the emergency emptying hose in its seat
after having plugged it.
9. Screw the water inlet hose back on.
Troubleshooting
Warning! Refer to Safety chapters.
Introduction
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer to the
table). If the problem persists, contact the Authorised
Service Centre.
With some problems, the acoustic signals operate
and the display shows an alarm code:
•
- The appliance does not fill with water
properly. Start the appliance again by pressing
Start/Pause button. After 10 seconds the door will
be unlocked.
• - The appliance does not drain the water.
• - The appliance door is open or not closed
correctly. Please check the door!
• - The mains supply is unstable. Wait until the
mains supply is stable.
• - No communication between electronic
elements of the appliance. Switch off and switch on
again. The programme was not finished properly or
the appliance stopped too early. If the alarm code
appears again, contact the Authorised Service
Centre.
Warning! Deactivate the appliance
before you do the checks.
Possible failures
Problem Possible solution
The programme does not start.
• Make sure that the mains plug is connected to the mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse box.
• Make sure that the Start/Pause has been pressed.
• If the delay start is set, cancel the setting or wait for the end of countdown.
• Deactivate the Child Lock function if it is on (if available).
20