User manual

Problem Possible solution
The laundry is full of different
coloured fluff:
The fabrics washed in the previous cycle released fluff of a different colour.
• Clean the clothes with a fluff remover
• The drying phase helps to eliminate some fluff.
In case of an excessive amount of fluff in the drum, refer to section «FLUFF IN
THE FABRICS».
• Thoroughly clean the empty drum, the gasket and the door with a wet rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
After the check, activate the appliance. The programme
continues from the point of interruption.
If the problem occurs again, contact the Authorised
Service Centre.
If the display shows other alarm codes. Deactivate and
activate the appliance. If the problem continues, contact
the Service.
Service
We recommend the use of original spare parts.
When contacting the Authorised Service Centre, make
sure that these data are available. You can find the
information on the rating plate: model, PNC and Serial
Number. (Mod., Prod. No., Ser. No.)
Installation
Warning! Refer to Safety chapters.
Unpacking
Remove all transit bolts and packing
before you use the appliance. You are
advised to keep all transit devices so t
hat they can be refitted if the appliance
ever has to be transported again.
• After removing all the
packaging, carefully lay
the appliance on it’s back
to remove the
polystyrene base from
the bottom.
• Remove the power
supply cable and the
draining hose from the
hose holders on the rear
of the appliance.
1
2
• Unscrew the three bolts.
• Slide out the relevant
plastic spacers.
22