User manual

• Hooked over the edge of a sink using the plastic

hose guide supplied with the machine.

In this case, make sure the end cannot come

unhooked when the appliance is emptying. This

could be done by tying it to the tap with a piece of

string or attaching it to the wall.

• In a sink drain pipe branch.

This branch must be above the trap so that the bend

is at least 60 cm above the ground.

• Directly into a drain pipe at a height of not less

than 60 cm and not more than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the drainpipe

must be larger than the outside diameter of the drain

hose. The drain hose must not be kinked.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece is

available from your local Service Centre

Building in

Overview

This appliance has been designed to be built into the

kitchen furniture. The recess should have the

dimensions shown in the picture below:

600 mm

555 mm

596 mm

170 mm

75 mm

100 mm

60 mm

min.

830 mm

min.

560 mm

818 mm

We recommend that you keep the

packaging and the transit bolts for any

movement of the appliance.

Installing anti-tiliting device

If the height of the counter is 820 mm or

lower, you cannot install the anti-tilting

device.

Remove the screws of the top cover on the rear of the

appliance and install the anti-tilting device as shown in

the drawing.