User manual

1
2
The distance between the holes hobs fixing centres
must be 416 mm. The distance from upper edge of the
door to the centre of the hole depends on the adjacent
furniture's dimensions.
Door mounting
To mount the door fix the hinges to the appliance using
the M5x15 screws.
Do not remove the screw B !!
The hinges can be adjusted to compensate for possible
uneven thickness of the door.
B
A
To align the door perfectly, loosen the screw, adjust the
door and tighten the screw A again.
The appliance is prearranged for a magnetic closure of
the door. To enable a correct operation of this device,
screw the counter-magnet A (steel disk + rubber ring)
into the inner side of the door.
Its position must correspond to the magnet B on the
appliance.
Do not remove the screw C !
A
B
C
If the door has to be opened from left to right, invert the
position of the plates E, the magnet D and the plate C.
Mount the counter-magnet D and the hinges A as
previously described.
Do not remove the screw B!
A
B
C
E
D
Technical Data
Dimension Width/ Height/ Depth/ Total
depth
596 mm/ 818 mm/ 544 mm/ 560 mm
26