User manual

General Safety
Do not change the specification of this appliance.
The appliance shall be installed as a freestanding product or below the
kitchen worktop if space margins permit.
Do not install the appliance behind a lockable door, a sliding door or a
door with a hinge on the opposite side, that would prevent the appliance
door from being fully open.
Connect the mains plug to the mains socket only at the end of the
installation process. Make sure that the mains plug is accessible after
installation.
The ventilation opening in the base must not be covered by a carpet, mat,
or any floor covering.
WARNING: The appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by a utility.
Ensure good air ventilation in the room where the appliance is installed to
avoid the backflow of unwanted gases into the room from appliances
burning gas or other fuels, including open fires.
Exhaust air must not be discharged into a flue which is used for
exhausting fumes from any appliances burning gas or other fuels.
The operating water pressure at the water entry point from the outlet
connection must be between 0.5 bar (0.05 MPa) and 8 bar (0.8 MPa).
Do not exceed the maximum load of 7 kg (refer to the "Programme chart"
chapter).
The appliance must be connected to the water mains using the new
supplied hose sets, or other new hose sets supplied by the Authorised
Service Centre.
Old hose sets must not be reused.
If the mains power supply cable is damaged, it must be replaced by the
manufacturer, its Authorised Service Centre or similarly qualified persons
to avoid an electrical hazard.
Wipe away lint or packaging debris that has accumulated around the
appliance.
Items that have been soiled with substances such as vegetable or mineral
oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes
and wax removers should be washed separately with an extra amount of
detergent before being dried in the washer dryer.
3