User manual

Select the required programme by turning the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme. The green pilot light of the button 5 starts to
flash.
The selector dial can be turned either clockwise or
counterclockwise. Turn to position «Off» to reset pro-
gramme/ switch the machine off.
At the end of the programme the selector dial must
be turned to position «Off» , to switch the machine
off.
Caution! If you turn the programme selector dial
to another programme when the machine is
working, the red pilot light of button 5 will blink 3 times
to indicate a wrong selection. The machine will not
perform the new selected programme.
Select the spin speed or Rinse Hold option by
pressing button 2
The relevant light will light up.
When selecting a programme, the light corresponding
to the maximum speed allowed for that programme will
illuminate.
Select the available options by pressing buttons 3
and 4
Depending on the programme, different functions can
be combined. These must be selected after choosing
the desired programme and before starting the pro-
gramme.
When these buttons are pressed, the corresponding pi-
lot lights illuminate. When they are pressed again, the
pilot lights go out. If an incorrect option is selected, the
integrated red pilot light of the button 5 flashes for 3
times.
For the compatibility among the washing pro-
grammes and the options see chapter «Washing
Programmes».
Select the Delay Start by pressing button 6
Before you start the programme, if you wish to delay
the start, press the button 6 repeatedly, to select the
desired delay. The relevant light illuminates.
You must select this option after you have set the pro-
gramme and before you start the programme.
You can cancel or modify the delay time at any mo-
ment, before you press button 5.
Selecting the delayed start:
1. Select the programme and the required options.
2. Select the delay start by pressing the button 6.
3. Press button 5:
– the machine starts its hourly countdown.
– The programme will start after the selected de-
lay has expired.
Cancelling the delayed start after having started the
programme:
1. Set the washing machine to PAUSE by pressing
button 5.
2. Press button 6 once, the light relevant to the se-
lected delay goes off
3. Press button 5 again to start the programme.
The Delay Start can not be selected with DRAIN pro-
gramme.
Important! The selected delay can be changed only
after selecting the washing programme again.
The door will be locked throughout the delay time. If
you need to open the door, you must set the machine
to PAUSE (by pressing the button 5) and then wait a
few minutes. After you have closed the door, press the
button 5 again.
Start the programme by pressing button 5
To start the selected programme, press the button 5,
the corresponding green pilot light stops blinking. The
pilot light corresponding to the running phase illumi-
nates. The appliance starts operating and the door is
locked.
To interrupt a programme which is running, press the
button 5: the corresponding green pilot light starts
blinking.
To restart the programme from the point at which it
was interrupted, press the button 5 again. If you have
chosen a delayed start, the machine will begin the
countdown.
If an incorrect option is selected, the red pilot light of
the button 5 blinks 3 times.
Interrupting a programme
Press the button 5 to interrupt a programme which is
running, the corresponding green pilot light starts blink-
ing.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off position to cancel a pro-
gramme which is running. Now you can select a new
programme.
12