User manual

Problem Possible cause/Solution
Spinning starts late or the ma-
chine does not spin:
The electronic unbalance detection device has cut in because the laundry
is not evenly distributed in the drum. The laundry is redistributed by re-
verse rotation of the drum. This may happen several times before the un-
balance disappears and normal spinning can resume. If, after 10 minutes,
the laundry is still not evenly distributed in the drum, the machine will not
spin. In this case, redistribute the load manually and select the spin pro-
gramme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the spin-
ning programme.
The machine makes an unusual
noise:
The machine is fitted with a type of motor which makes an unusual noise
compared with other traditional motors. This new motor ensures a softer
start and more even distribution of the laundry in the drum when spinning,
as well as increased stability of the machine.
No water is visible in the drum:
Machines based on modern technology operate very economically using
very little water without affecting performance.
If you are unable to identify or solve the problem, con-
tact our service centre. Before telephoning, make a
note of the model, serial number and purchase date of
your machine: the Service Centre will require this infor-
mation.
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ... ... ...
Mod
. ..
. ...
...
P
r
od. N
o
.
... ... ..
S
e
r
.
No
.
... ...
...
Technical data
Dimensions Width / Height / Depth 600 / 850 / 540 mm
Electrical connection Voltage
Overall power
Fuse
Frequency
230-240 V
2050 W
13 A
50 Hz
Water supply pressure Minimum
Maximum
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Level of protection against ingress of solid particles and moisture IPX4
Water supply
1)
Cold water
Maximum Load Cotton 7 kg
Spin Speed Maximum 1200 rpm
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
18