User manual

Installation
Unpacking
All transit bolts and packing must be removed before
using the appliance.
You are advised to keep all transit devices so that they
can be refitted if the machine ever has to be transpor-
ted again.
After removing all the
packaging, carefully lay
machine on it's back to
remove the polystyrene
base from the bottom.
Remove the power sup-
ply cable and the hose
from the hose holders on
the rear of the appliance.
Unscrew the three bolts
with the supplied span-
ner.
Slide out the relevant
plastic spacers.
Fill the smaller upper hole and the two large ones
with the corresponding plastic plug caps supplied in
the bag containing the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that
air circulation around the machine is not impeded by
carpets, rugs etc. Check that the machine does not
touch the wall or other kitchen units.
Level the washing ma-
chine by raising or lower-
ing the feet. The feet
may be tight to adjust as
they incorporate a self
locking nut, but the ma-
chine MUST be level and
stable. If necessary,
check the setting with a
spirit level.
Any necessary adjust-
ment can be made with a
spanner.
Accurate levelling prevents vibration, noise and dis-
placement of the machine during operation.
Caution! Never place cardboard, wood or similar
materials under the machine to compensate for
any unevenness in the floor. After having levelled the
appliance, tighten the lock nuts.
Raising the appliance
Suspended wooden floors are particularly susceptible
to vibration.
To help prevent vibration we recommend you place a
waterproof wood panel, at least 15 mm thick under the
appliance, secured to at least 2 floor beams with
screws, the wood panel must extend beyond the front
feet.
If possible install the appliance in one of the corners of
the room, where the floor is more stable.
19