User manual

Min. 60 cm (23.6”)
Max. 90 cm (35.4”)
If your drain hose looks
like this (see beside) you
do not require the “U”
piece”. Just push the
hose firmly in to the
standpipe.
2. Onto a sink outlet spigot.
Loop
If the outlet spigot has
not been used before, re-
move any blanking plug
that may be in place.
Push the drain hose onto
the spigot and secure
with a clip, ensure a loop
is formed in the drain
hose (see above) to pre-
vent waste from the sink
entering the appliance.
If you intend to drain the hose from the machine into
a sink, make sure that the sink is empty and the plug
hole is not blocked. Use the plastic “U - Piece” sup-
plied.
In the interest of the environment
The appliance should be connected to the FOUL drain-
age system, the water will then be taken to a sewage
works for treatment before being discharged safely into
a river.
It is essential that these appliances are not connected
to the surface water drainage system as this water is
discharged directly into a river or stream and may
cause pollution.
If you require any further advice please contact your lo-
cal water authority.
SHOWER
WASHING
MACHINE
DISHWASHER
BATH
SINK
TOILET
BIDET
RAINWATER
‘RUN-OFF’
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER RIVER
TREATED DISCHARGE
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
Building in
This appliance has been designed to be built into the
kitchen furniture. The recess should have the dimen-
sions shown in picture A.
21