User manual

Where the appliance has been raised by mounting
onto a wooden base provided by the installer. The
material used to construct the base should have
anon slip surface, be water repellent and if possible
be one solid piece.
If it is not possible to use one solid piece, due to the
additional height required, ensure that any additional
strips of timber are glued and screwed to the under-
side of the base (see Fig. F).
Graphic G
Top view
Front edge
600-605
490
95
50
Drill four fixing holes see Fig. G
Position the base into the recess with its front edge
as far forward as the adjoining plinth line will allow.
The reason for placing the base in this position
is to allow a small strip of beading to be fitted in
front of the appliance feet.
Graphic H
600-605
490
5 x 25 x 605
Hardwood strip
5 mm x 25 mm
Fix the base firmly to the floor using four appropriate
countersunk screws (see Fig. H).
With the appliance installed adjust all four feet ensur-
ing the machine is stable, and a clearance of approx-
imately 5 mm is left between the top of the machine
and the underside of the worktop.
A final check for stability should be carried out with
the machine on spin with a load, this will identify the
need for any further fine adjustment to the feet.
A strip of beading approximately 605 mm W, x 5 mm
H, x 25 mm D must be screwed down into the base
directly in front of the machine’s feet, this will provide
additional security.
If required an additional door magnet, part number
1242394-00/3 and disc, part number 1242393-00/5
are available from spare parts.
Environmental concerns
Recycle the materials with the symbol . Put the
packaging in applicable containers to recycle it.
Help protect the environment and human health and to
recycle waste of electrical and electronic appliances.
Do not dispose appliances marked with the symbol
with the household waste. Return the product to your
local recycling facility or contact your municipal office.
Packaging materials
The materials marked with the symbol
are recycla-
ble.
>PE<=polyethylene
>PS<=polystyrene
>PP<=polypropylene
This means that they can be recycled by disposing of
them properly in appropriate collection containers.
24