User manual

Problem Possible solution
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is not clogged.
Make sure that the inlet hose has no kinks or bends.
The appliance does not drain the water. Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
The anti-flood device is on. Close the water tap and contact the Service.
After the checks are completed, activate the appliance.
The programme continues from the point of interruption.
If the problem occurs again, contact the Service.
If other alarm codes appear, contact the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on glasses and
dishes
• The released quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses and dishes
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid selector to a higher position.
• The quality of the detergent can be the cause.
Dishes are wet
• The programme is without a drying phase or with a
low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
Refer to ‘HINTS AND TIPS’ for other possible cau-
ses.
Technical information
Dimensions Width / Height / Depth (mm) 596 / 818 - 898 / 555
Electrical connection Refer to the rating plate.
Voltage 220 - 240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity Place settings 12
Power consumption Left-on mode 0.99 W
Off-mode 0.10 W
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot water supply to
decrease energy consumption.
12