User manual
11
The Instructions for Use apply to
several versions of this appliance.
Accordingly, you may nd descrip-
tions of individual features that do
not apply to your specic appliance.
The manufacturer will not be held li-
able for any damages resulting from
incorrect or improper installation. The
minimum safety distance between
the cooker top and the extractor hood
is 650 mm (some models can be in-
stalled at a lower height, please refer
to the paragraphs on working dimen-
sions and installation). Check that the
mains voltage corresponds to that
indicated on the rating plate xed to
the inside of the hood. For Class I
appliances, check that the domestic
power supply guarantees adequate
earthing. Connect the extractor to the
exhaust ue through a pipe of mini-
mum diameter 120 mm. The route of
the ue must be as short as possible.
Do not connect the extractor hood to
exhaust ducts carrying combustion
fumes (boilers, replaces, etc.). If the
extractor is used in conjunction with
non-electrical appliances (e.g. gas
burning appliances), a sufcient de-
gree of aeration must be guaranteed
in the room in order to prevent the
backow of exhaust gas. The kitchen
must have an opening communicat-
ing directly with the open air in order
to guarantee the entry of clean air.
When the cooker hood is used in con-
junction with appliances supplied with
energy other than electric, the nega-
tive pressure in the room must not
exceed 0,04 mbar to prevent fumes
being drawn back into the room by
the cooker hood. The air must not be
discharged into a ue that is used for
exhausting fumes from appliances
burning gas or other fuels (not ap-
plicable to appliances that only dis-
charge the air back into the room). In
the event of damage to the power ca-
ble, it must be replaced by the manu-
facturer or by the technical service
department, in order to prevent any
risks. If the instructions for installa-
tion for the gas hob specify a greater
distance specied above, this has to
be taken into account. Regulations
concerning the discharge of air have
to be fullled. Use only screws and
small parts in support of the hood.
Warning: Failure to install the screws
or xing device in accordance with
these instructions may result in elec-
trical hazards. Connect the hood to
the mains through a two-pole switch
having a contact gap of at least 3
mm. The extractor hood has been
designed exclusively for domestic
use to eliminate kitchen smells. Nev-
er use the hood for purposes other
than for which it has been designed.
Never leave high naked ames under
the hood when it is in operation. Ad-
just the ame intensity to direct it onto
the bottom of the pan only, making
sure that it does not engulf the sides.
Deep fat fryers must be continuously
monitored during use: overheated oil
can burst into ames. Do not ambè
under the range hood; risk of re.
This appliance can be used by chil-
dren aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or lack
of experience and knowledge if they
have been given supervision or in-
EN - User Manual