User Manual

KH 80 DSP | 8
Connecting network cables
To use the extended functionality oered by the Neumann.Control software, the loudspeaker
must be connected to a standard network switch using a user supplied standard Ethernet cable
(Cat 5 or better). The maximum length of the cable is 100 m.
Refer to the Neumann.Control software help for information about how to use loudspeakers in
a network.
RJ45 RJ45 RJ45RJ45
Network Switch
Connecting/disconnecting the KH 80 DSP to/from
the mains power supply
To connect the KH 80 DSP to the mains power supply:
X
Make sure that the on/o switch is set to “OFF”.
X
Connect the figure-8 connector of the supplied mains cable to the mains socket.
Power Source
X
Connect the mains plug of the mains cable to a suitable wall socket.
To disconnect the KH 80 DSP from the mains power supply:
X
Set the on/o switch to “OFF”.
X
Pull the mains plug out of the wall socket.
EN