User Manual

KH 80 DSP | 9

Conﬁguring and using the KH 80 DSP

Switching the KH 80 DSP on/oﬀ

On/Oﬀ

Set the on/o switch to:

• “ON” to switch on the loudspeaker. The Neumann logo lights up solid red while the

DSP system boots up. After approximately 5 seconds it turns white indicating the loud-

speaker is ready to be used. If the logo brightness has been set to less than 100% in the

Neumann.Control software, it will be dimmed or o after the bootup phase is complete.

• “OFF” to switch o the loudspeaker. The Neumann logo switches to red for a short moment

and then goes o.

There is a ﬁve second delay before sound can be heard from the loudspeaker in order

to avoid noises (pops) from preceding equipment switched on at the same time. Con-

versely, switching o the loudspeaker immediately mutes the audio.