User's Manual
MA 1 – Automatic Monitor Alignment | 11
Selecting the loudspeakers from the network
The soware lists all loudspeakers/subwoofers found in the network.
If there are loudspeakers missing in the list or no loudspeakers at all, check the following
aspects:
X
Ensure that device discovery is activated in your network. This functionality could be labelled
MDNS, UPnP, IGMP or Bonjour.
X
The machine that runs this application needs to use the same network as your Neumann DSP
devices.
X
Make sure all Neumann DSP devices are connected to the same router or switch.
X
Be sure all DSP devices are switched on.
X
Ensure that the Neumann DSP devices are not in standby mode. If they are play some audio
to wake them up.
X
Switch the Neumann DSP devices o and on and wait for 60 seconds.
X
Perform a factory reset (see below).
Factory reset for the KH 80 DSP
To reset the KH 80 DSP internal controls to their factory default values:
X
Switch on the KH 80 DSP.
X
While the logo is still red indicating boot up move the SETTINGS switch up and down repeat-
edly until a few seconds aer it turned white.
Automatic (default): The subwoofer automatically chooses between analog or digital (AES3)
input signals. Digital signals have priority over analog signals.
The logo will then start utter ash red for a few seconds before reverting to white.
Factory reset for the KH 750 DSP
To reset the KH 750 DSP internal controls to their factory default values:
X
Switch on the KH 750 DSP.
X
While the power light is solid red during the boot up phase, move the STANDBY switch up
and down repeatedly.
The power light will then ash red while the default settings are being applied before reverting
to green.