User's Manual
MA 1 – Automatic Monitor Alignment | 12
In order to identify which loudspeaker/subwoofer in the list is which loudspeaker/subwoofer
in your room you can click on the Neumann logo next to the loudspeaker/subwoofer.
The logo on the front of the loudspeaker/the power LED on the subwoofer rear will ash rosé.
Selecting loudspeakers in a setup with DSP loudspeakers only
X
From the list, select the loudspeakers which belong to your system.
X
Choose the position the loudspeaker is placed.
Selecting loudspeakers in a setup of a DSP subwoofer with analog loudspeakers
X
From the list, select the subwoofer which belongs to your system.
X
Select the input signal option of the subwoofer.
• Automatic (default): The subwoofer automatically chooses between analog or digital
AES3 input signals. Digital signals have priority over analog signals.
• Analog: If analog is selected, only analog input signals will be received even if there are
digital signals connected.
X
Choose the corresponding analog version if you use D-versions of the loudspeakers (KH 120,
KH 310, KH 420).
X
Make sure the loudspeakers are connected according to their physical position (le output
of KH 750 DSP to le loudspeaker, etc.).
Adapting the output level
X
Click START to start the output signal level adaptation.
The system identies the correct signal level which is then applied to the loudspeakers.
During this process the loudspeakers are muted.
If the output level of your audio interface too low, the system will ask you to adapt it accord-
ingly.