User's Manual
MA 1 – Automatic Monitor Alignment | 13
X
Make sure both the le and the right channel are connected and have the same signal gain
(panorama center).
X
Do not change the output level of your audio interface until all measurements are done.
Once the level is set correctly, the system will inform you.
If this test failed please check the following points:
X
Loudspeakers/subwoofer are set to network at their back
X
Proper audio connection from audio interface to loudspeaker/subwoofer
X
Source output not muted
Positioning the microphone and loudspeakers/subwoofer
Before the alignment you need to ensure that your loudspeaker system is set up correctly.
X
Arrange the loudspeakers and the listening position as an equilateral triangle. The distance
between the tweeters of the loudspeakers and between tweeter and listening position is
identical.
X
Place the loudspeakers and all equipment/furniture as symmetrical as possible with regard
to the listening axis.
X
Angle the loudspeakers horizontally and vertically towards the listening position.
X
Measure the distance between the le and right tweeter and enter it in the text eld.
Give in the measured distance between le and right tweeter (same as between tweeter and
listening position).
MA 1 input channel
Measuring the signal chain and background noise
Before starting, make sure that:
X
The microphone input gain of your microphone preamplier is set to a reasonable value.
X
All windows are closed.
X
No fans, air conditioning devices or other noise generating devices are running.
X
Nobody is talking or walking around.
X
The phantom power of your microphone preamp is switched on.