User's Manual
MA 1 – Automatic Monitor Alignment | 17
The combination of all measured loudspeakers/subwoofer with their default settings is shown
in white.
Editing the target response
Aer the automatic alignment you can play any signal through your audio interface to your
loudspeakers and listen to the result.
By selecting and unselecting the ACTIVATE AUTOMATIC ALIGNMENT checkbox you can switch
between with and without alignment.
Please note it will take a few seconds until all parameters have been transferred completely to
the loudspeakers.
The EQ section below the graph now allows you to modify the result.
Please note that you can only modify the orange target response, not the measured curve. The
target response can be modied with 8 fully parametric and two xed shelf EQs.
Activating an EQ
X
Select the EQ-specic checkbox
X
Enter frequency, gain and Q
You can also change gain and frequency by grabbing the highlighted EQ number and moving
it up, down, le, or right.
The eect will become visible immediately on the orange target response for all selected
lters.