User's Manual

MA 1 – Automatic Monitor Alignment | 19
Saving the results
A er performing all modi cations the results need to be stored permanently in the loudspeak-
ers.
X
Click Save and Close.
The alignment process is now  nished. The loudspeakers will permanently use the alignment.
You can now disconnect the loudspeakers from the network.
To compare with the local backplate settings of the connected DPS loudspeakers/subwoofer,
you can set the Network switch on their back to LOCAL.
All monitors and subwoofers need to be set to local, as the so ware wrote alignment param-
eters to both the KH 80 and the KH 750.
Note! Do not change any settings at the backplate of the DSP loudspeakers/subwoofer during
the alignment process.
If you set the switch back to NETWORK, the previously stored calibration will be active again.
Please note that if you want to recalibrate the system, the alignment process needs to be
started from the beginning.
You cannot recall the result screen a er the application has been closed.