User's Manual

MA 1 – Automatic Monitor Alignment | 4
System setup
Proceed as follows to set up the system.
Compatibility with Neumann.Control iPad app
X The MA 1 – Automatic Monitor Alignment is not compatible with Neumann.Control iPad app.
Use either the one or the other.
X Using the Neumann.Control app before, while or a er using the MA1 – Automatic Monitor
Alignment app may cause invalid alignment results. To be certain that the alignment is and
stays correct please:
X Uninstall the Neumann.Control app from your iPad.
X Perform a factory reset on your Neumann DSP devices (see below).
X Use the MA 1 – Automatic Monitor Alignment app to align your system.
X Do not use the Neumann.Control app on an aligned system.
X Once the MA 1 so ware has started and connected to the loudspeakers previously stored
parameters from MA 1 alignment sessions before or from Neumann.Control setups are deleted.
X Neither MA 1 alignments nor Neumann.Control setups can be stored in the MA 1 so ware.
X If a er the MA 1 alignment procedure the Neumann.Control iPad app is connected to the
loudspeakers the MA 1 alignment will be overwritten by the iPad. To get back to the MA 1
automatic alignment the MA 1 alignment procedure must be redone.
Connecting the hardware
X
Connect your hardware as shown in this diagram
Setting up the loudspeakers
X
Set the switch positions and level adjustments on the rear of your loudspeakers/subwoofer
according to the following instructions.
Analog monitors in combination with KH 750 DSP
(KH 750 DSP + KH 120/KH 310/KH 420)