User Manual

ALTERNATE CONTROLS
These controls are accessed by holding down the Engage footswitch
while turning the knob.
Gate
The Gate control adjusts the noise reduction threshold. Fully counter-clockwise is
o. Set the Noise Gate as follows:
1. Press and hold the Engage switch.
2. Start with the Gate knob fully counter-clockwise.
3. Slowly turn the knob clockwise until the noise attenuates. Stop and release
the switch.
Tightness
The Tightness control adjusts a pre-gain high-pass filter. Increasing this control
will tighten the low end with high-gain settings. Increase the Low control to
compensate for any reduction of low frequencies.
Presence
The Presence control adjusts a post-gain low-pass filter.
FOOTSWITCHES
Preset
The Preset switch selects a stored preset. The LED illuminates when a preset is
selected. For more information, refer to the Using Presets section.
Engage
The Engage switch selects between engaged and bypassed. The LED illuminates
when the pedal is engaged.