17" & 19 Keyboard User Guide

RFT2 Rack Kit Installation Guide

07/01/06 Rev 1.0 Page 6 of 13

Cable Management Installation

1. With the RFT installed, go to the back of the rack to

install the cable management system.

2. Attach Part A to part extension of outer member on

the left slide.

3. Connect Part B to the inside right hand side slide

member by sliding it into place. A “click” will be heard

once it is secured. The Cable Management System

is designed to have the cross-support beam on the

bottom…not the top.

4. Connect Part C to the outside right hand side slide

member. Note that the extruded portion on the top of

Part C needs to line up with the mating portion on the

outer slide member. Similar to Step 2 above. A “click”

will be heard once it is secured.

5. Insert Part D into Part A on the left hand side. The

large tab on Part A will keep Part D in place.

Part

Note the guide that will fit into

the mating portion on the slide

Part