Instruction Manual

First slide the housing onto the cable and insert the
sealing cap A into the other hole.
Prepare the cable by stripping 25 mm of the
jacket.
Reduce the shielding strands to a length of 7mm
and bend them over the jacket.
Shorten the wires and strip the insulation as
indicated in figure 2.
Slide the prepared end of the cable into
the open end of the plug, so that 9 mm of
unstripped cable restsinside the plug.
Next crimp the end of the plug with a standard
6.35 mm hexagonal crimping tool (RG 58).
Crimp only in the area designated in figure 4!_
figure 2
figure 3
figure 4
figure 1
NEUTRIK
NP3TT-2
A
7
15
20
25
10
3
T1
R1
T2
R2
NEUTRIK
NP3TT-2
ASSEMBLY INSTRUCTION
Dual Plug
NP3TT-2
|
0.173” (4.4 mm) BANTAM-TYPE
MINIATURE PLUGS
Page 1