User guide

G
H
Slide the boot onto the cable.
Slide the crimp strain relief onto the cable jacket to
the position as indicated.
Crimp the strain relief by means of HEX crimp dies of
width 6.5 mm (size ”E” acc. to IEC 60803).
Solder the wire ends to contacts #2 and #3 of insert.
Position the distance sleeve between strain relief
and insert.
Align the nose of the crimp strain relief and the
recess of the distance sleeve with respect to one of
the keyways.
Slide the unit into the connector housing.
Finish the installation by turning the bushing onto
the connector.
Prepare cable as shown. Fold back the shield. If the
cable does not offer a drain wire, twist a part of the
shield for contact 1 shield wiring.
#
NOTE: To keep the strain relief in the
keyway, avoid rotation of the cable
during assembly.
A
B
C
D
E
F
G
H
A
B
C
E
F
D
Drain wire or
part of shield!
23
4
ASSEMBLY INSTRUCTION
NEUTRIK AG
NEUTRIK Zürich AG
NEUTRIK USA Inc.
NEUTRIK UK Ltd.
()
LI
CH
USA
UK
T: F:
T: F:
T: F:
T: F:
+423 / 237 24 24 +423 / 232 53 93
+41 44 / 736 5010 +41 44 / 736 5011
+1 732 / 901 9488 +1 732 / 901 9608
+44 1983 / 811 441 +44 1983 / 811 439
NEUTRIK
NEUTRIK France
NEUTRIK Tokyo Ltd.
NEUTRIK
Vertriebs GmbH
Ltd.Hong Kong
DE /NL / AT
FR
JP
HK
T: F:
T: F:
T: F:
T: F:
+49 8131 / 280 890 +49 8131 / 280 830
+33 1 / 4131 6750 +33 1 / 4131 0511
+81 3 / 3663 4733 +81 3 / 3663 4796
+852 / 2687 6055 +852 / 2687 6052
ASSEMBLY INSTRUCTION
NC3MXCC XLR Cable Connector
|
Draft. Nr.: BDA 106 Update: 28.09.2009/ 3102M11211
II
Data subject to change without prior notice. 2009 NEUTRIK . ALL RIGHTS RESERVED.©
®