Owner manual

opticalCON

NO2-4FDW-A Soldering Instruction

Page 1

HANDLING INSTRUCTION

Strip all 4 copper cords at a length of

3 mm, while using the baring tool.

Slide the prepared shrink tube with a length

of 10 mm over copper cord (pin 1 and 4).

Pre-solder tip of the copper cords for

enhanced heat transfer.

ATTENTION! Don’t use too much solder.

Cable Preparation

A. HANDLING INSTRUCTION

PAGE 1
R HANDLING INSTRUCTION opticalCON | NO2-4FDW-A Soldering Instruction A. HANDLING INSTRUCTION Cable Preparation A Strip all 4 copper cords at a length of 3 mm, while using the baring tool. 3 B Slide the prepared shrink tube with a length of 10 mm over copper cord (pin 1 and 4). C Pre-solder tip of the copper cords for enhanced heat transfer. ATTENTION! Don’t use too much solder.
PAGE 2
opticalCON - Handling Instruction I NO2-4FDW-A Page 2 Cable Soldering D Insert pre tinned copper cords into the terminals and solder them on. Attention: Do not use too much solder. Avoid cold solder joints! Cable Shrinking E Slide heat shrink over solder joint and shrink it with a hot air gun. Attention: Set appropriate temperature according used wires and shrink tube. HOT AIR GUN B. Finished Product Solder cups completely covered with heat shrink. No “cold” solder joints.