Instruction Manual

Slide the bushing over the cable.
Assembly the RJ45 plug on the cable.
Cut off release tab of RJ 45 plug.
Put chuck onto the cable.
If applicable press the adapter into the port.
Position the ring on the cable end
.
Slide the connector into the housing.
Slide the chuck in the housing
.
Slide the boot to the housing and tighten
the bushing .
(flush to the face)
pay attention: the connector latch has to point
downwards (opposite direction of RJ45 lettering)
(pay attention to the guiding key)
(max. torque 3 Nm)
CAUTION:
In combination with ( D )the position ring ( E )
can but must not be used depending to the
design of the RJ45 plug.
A
B
C
E
F
H
A
D
G
B
D
E
standard version
E
or
C
Draft. Nr.: BDA 132 Update: 04.02.2013/ 3102M1261
II
Data subject to change without prior notice. 2013 NEUTRIK . ALL RIGHTS RESERVED. NEUTRIK are registered trademark.©
® ®
www.neutrik.com
ASSEMBLY INSTRUCTION
etherCON
NE8MC-1, Ruggedized RJ 45
Data Connector with X Series bushing
|
special version
B1
B1
NEUTRIK AG
NEUTRIK USA Inc.
NEUTRIK UK Ltd.
NEUTRIK
T: F:
T: F:
()
T: F:
T: F:
LI
USA
UK
DE/NL/AT/DK
+423 / 237 24 24 +423 / 232 53 93
+1 704 / 972 3050 +1 704 / 438 9202
+44 1983 / 811 441 +44 1983 / 811 439
+49 8131 / 280 890 +49 8131 / 280 830
Vertriebs GmbH
NEUTRIK France
NEUTRIK Tokyo Ltd.
NEUTRIK
FR
JP
HK
T: F:
T: F:
Ltd. T: F:
+33 1 / 4131 6750 +33 1 / 4131 0511
+81 3 / 3663 4733 +81 3 / 3663 4796
+852 / 2687 6055 +852 / 2687 6052Hong Kong
R
R
F
G
H
RJ45
RJ45
max. 0.25 mm