Manual
ATTENTION:
DO NOT CRIMP!
Attention:
Align lug to the top!
Pay attention to correct wiring!
Cable length protruding the panel should
give enough space for crimp operation.
Position a contact in the die and hold the
contact by pressing the tool slightly
together -
Position the wire in the contact & crimp it.
Push the crimped contacts into the insert
until you notice a snap.
PIN 1 … Screen
PIN 2 … Hot, +
PIN 3 … Cold, -
Position the connector in the panel and
fasten it.
Standard crimp according IEC 60352-2 (B crimp).
Wire size AWG 22 - 24, 0.22 - 0.34 mm .
2
Prepare cable as shown (twist the screen).
Repeat steps C, D, E for the remaining two
contacts.
EXTRACTION OF CONTACT
1. Turn the contact 90°
2. Pull the contact out of the insert
3. Insert new Contact
A
B
C
E
F
D
A
B
-1-
Panel
C
D
Snap
F
E
18
[0.7”
]
[0.7”
]
3
[0.12”
]
[0.12”
]
NC3FD-LX-HA DLX Serie - Crimp XLR Chassis Connector
|
ASSEMBLY INSTRUCTION
1.
2.