R HANDLING INSTRUCTION opticalCON MTP ® | Maintenance R www.neutrik.
opticalCON MTP I HANDLING INSTRUCTION ® CAUTION: Laser radiation, do not look directly into beam of light! Do not disassemble the opticalCON MTP® cable connector if not required. The sealing shutter mechanism of the opticalCON avoids contamination of the MTP® ferrule locked inside. The dust-proof design reduces maintenance intervals to a minimum; if nevertheless necessary, follows the maintenance procedure below to avoid damages on the due to inpropes cleaning. A.
R HANDLING INSTRUCTION I opticalCON MTP® B. Inspection - MTP ® ferrule For fiber inspection use available video probe MTP ® – adapter and monitor. Listed products below are approved and correspond with the opticalCON MTP ® cable connector and chassis. Comparable devises may be used from alternative brands. Tools: JDSU HD3-P* (Fiber Monitor) JDSU FBP-P5* (Video Probe) JDSU FBPT-MTP* (MTP Adapter) During inspection procedure, make sure that each ferrule is completely free of dust.
R HANDLING INSTRUCTION I opticalCON MTP® C. Chassis Cleaning Dry cleaning using FOCD-DC-MTP® 1. Remove dust cap and insert the tip of the dry cleaning cleaner 2. 2. Guide the tip to the dry cleaner into the chassis housing. 3. Rotate the plastic wheel to start the cleaning procedure. An endless lint free tape removes dust particle on the ferrule surface of the MTP® connector on the rear of the chassis. Dry cleaner 4. After cleaning procedure, remove dry cleaner and coves the tip with the dust cap.
