Setup instructions

1. Push bushing and cover onto cable
2. Cable preparation
3. Insert the prepared cable into the connector
4. Soldering
5. Hex-Crimping
Solder the inner leads to the solder cups. Make sure that the central cup is properly covered with solder thus securing the threaded joint
between tip and cup.
To connect the ground and for proper cable retention: crimp the rear part of the connector with the NEUTRIK Crimp tool.
Recommendation: Check electrical connection before final assembly.
max. DIA 4.8
[
0.19”
]
TIP
RING
Ground (Sleeve)
fold back shield
6. Move forward bushing and cover as far as easily possible.
7. Final assembly:
Insert into the tool - press together.
10.0 [0.39”] 10.6 [0.41”]
3.0 [0.12”]
17.0 [0.67”]
3.0 [0.12”]
max. 5.1 [0.20”]Æ
Assembly tool:
The HX-TT-1 consists of a crimp
tool and a press tool für NP3TT-1-*.
ASSEMBLY INSTRUCTION
NP3TT-1
|
0.173” (4.4 mm) BANTAM-TYPE
MINIATURE PLUGS
NEUTRIK AG
NEUTRIK Zürich AG
NEUTRIK USA Inc.
NEUTRIK UK Ltd.
()
LI
CH
USA
UK
T: F:
T: F:
T: F:
T: F:
+423 / 237 24 24 +423 / 232 53 93
+41 44 / 736 5010 +41 44 / 736 5011
+1 732 / 901 9488 +1 732 / 901 9608
+44 1983 / 811 441 +44 1983 / 811 439
Draft. Nr.: BDA 030 Update: 28.09.2009/ 3102M1341
II
Data subject to change without prior notice. 2009 NEUTRIK . ALL RIGHTS RESERVED.©
®
NEUTRIK
NEUTRIK France
NEUTRIK Tokyo Ltd.
NEUTRIK
Vertriebs GmbH
Ltd.Hong Kong
DE / NL/AT
FR
JP
HK
T: F:
T: F:
T: F:
T: F:
+49 8131 / 280 890 +49 8131 / 280 830
+33 1 / 4131 6750 +33 1 / 4131 0511
+81 3 / 3663 4733 +81 3 / 3663 4796
+852 / 2687 6055 +852 / 2687 6052
www.neutrik.com