Operation Manual

DAZD 3.7 Li B1

■ 4

│

CAUTION – PROPERTY DAMAGE!

► The electric toothbrush may only be recharged with the sup-

plied charger. The appliance could otherwise be irreparably

damaged!

► Only operate the appliance with the original accessories

supplied.

Set-up / wall bracket

NOTE

►

The charger  may only be operated free-

standing if used in dry rooms.

► In damp rooms, especially in the vicinity of

water (bath), the charger  must be ﬁrmly

ﬁxed to the wall to protect it from falling into

water.

1) Press the small stand on the wall bracket 

from below until this releases from the

charger :

2) Then pull the wall bracket  downwards

from the charger :

3) Using the screw holes of the wall bracket ,

mark the spacing for the boreholes on the

wall. Check to ensure that there is a mains

power socket in close vicinity.

4) Before drilling the holes, check to ensure that

there are no electrical cables or water pipes

behind the markings.

5) Use a 5 mm drill bit to drill the required holes

and insert the wall plugs.

6) Aﬃx the wall bracket  using the screws

provided.

7) After you have attached the wall bracket ,

guide the power cable through the right or left

cut-out in the charger  (see magniﬁcation on

the fold-out page). Using the guide rails, slide

the charger  onto the wall bracket .

8) Ensure that the power cable is not trapped

and that it lies properly in the cut-outs.