Operation Manual

4
NAZ 2.4 A1
GB
IE
CAUTION – PROPERTY DAMAGE!
► The electric toothbrush may only be recharged with the supplied
charger. The appliance could otherwise be irreparably damaged!
► Only operate the appliance with the original accessories supplied.
Set-up/wall bracket
NOTE
►
The charger 8 may only be operated free-
standing if used in dry rooms.
► In damp rooms, especially in the vicinity of
water (bath), the charger 8 must be fi rmly
fi xed to the wall to protect it from falling into
water.
1) Pull the wall bracket 9 downwards from
underneath the charger 8.
2) Using the screw holes of the wall bracket 9,
mark the spacing for the boreholes on the
wall. Check to ensure that there is a mains
power socket in close vicinity.
3) Before drilling the holes, check to ensure that
there are no electrical cables or water pipes
behind the markings.
4) Use a 5 mm drill bit to drill the required holes
and insert the supplied wall plugs.
5) Attach the wall bracket 9 using the screws
provided.
6) After you have attached the wall bracket 9,
push the charger 8 a short way onto the
wall bracket 9. The mains cable should lie
in the middle. Guide the mains cable through
the right-hand or left-side recesses on the wall
bracket 9 and then push the charger 8 all
the way onto the wall bracket 9.
7) Ensure that the mains cable is not trapped
and that it lies properly in the recess.
First use
NOTE
Before starting to use the appliance, check that
it is in fault-free condition. If it is not, it must not
be used.
1) Insert the plug into the mains power socket.
2) Before initial use, clean the new brush heads 2
with fresh water.
3) Open the lid 1 of the charger 8 and place
the replacement brush heads on the brush
holders. Re-close the lid 1.
4) Place the handset on the charger 8 so that
it slides onto the pin on the base.
5) Allow the handset to charge up for around
14 - 16 hours before using it for the fi rst
time. The charge indicator 7 on the front of
the hand appliance lights up red during the
charging process.
6) Use the handset repeatedly without charging
the battery until the performance becomes
noticeably weaker or the toothbrush stops
working and the charge indicator 7 blinks red.
Then recharge the battery for 14 - 16 hours.
When the appliance is fully charged, the
charge indicator 7 lights up green.
7) Charge and discharge the toothbrush com-
pletely 3 times. The battery will have then
reached its full capacity.
8) You can now leave the handset in the char-
ger 8 after every use, so as to always have
full power available.
IB_42776_NAZ2.4A1_LB3.indb 4 12.11.14 10:14