Operation Manual

NAZ 2.4 B2
■ 6
│
GB
│
IE
NOTE
To avoid spray, do not switch on the appliance
until it is in your mouth
4) Use the on/off switch  to select the desired
operating mode.
NOTE
This toothbrush has a 30-second interval timer,
so that all four jaw quadrants can be cleaned
evenly.
5) Divide your mouth into four parts (quadrants):
upper left, upper right, lower left and lower
right.
6) Start in one quadrant:
Start with the brush head  on your gums,
and move the brush upwards/downwards
from the gums to the crown of the tooth.
Proceed in this manner on both the inside and
the outside of the tooth. Start again at the gums
for each individual tooth.
Do not forget to brush the back of the rear
molars.
To clean the chewing surfaces, guide the
rotating brush head over the chewing sur-
faces with a little pressure.
7) After 30 seconds, the toothbrush stops briefly
to signal that you should start cleaning the
next quadrant. Clean each jaw quadrant
using the same technique.
8) After two minutes the toothbrush stops its
operation briefly 4 times. This informs you that
you have complied with the dental recommen-
dation of two minutes cleaning.
9) Press the on/off switch  repeatedly until the
toothbrush stops.
10) Then take the toothbrush out of your mouth.
11) After use, rinse the brush head  thoroughly
under running water.
12) Remove the brush head  from the handset.
To clean the drive shaft and the handset,
allow a little water to flow over them. Hold
the handset so that the drive shaft is pointing
downwards.
NOTE
Regularly massage your gums. This promotes
blood circulation and helps to keep them healthy.
Set the mode to "Pulse" and guide the moistened
brush over your gums with a light pressure.