Operation Manual

NSZB 3.7 B2
GB
│
IE
│
NI
│
5 ■
Operation
This toothbrush has 3 different power levels:
– “Clean”: normal speed, orange “Clean” LED 
For cleaning the teeth.
– “Soft”: slow speed, green “Soft” LED 
For cleaning the teeth of people with sensitive gums.
– “Pulse”: slow speed with short breaks, yellow “Pulse” LED 
For massaging the gums.
■ Press the on/off switch  once to activate the “Clean” mode. The “Clean”
LED  lights up.
■ Press once more to switch to “Soft” mode. The “Soft” LED  lights up.
■ Press it a third time to switch to “Pulse” mode. The “Pulse” LED  lights up.
■ To switch the toothbrush off, press the on/off switch  once more.
Brushing Teeth
WARNING!
The unfamiliar stimulation may cause light gum bleeding at first. This is normal.
If this continues for more than two weeks, you should consult your dentist.
1) Place the brush head  on the handset.
2) Moisten the brush under flowing water.
3) Put a little toothpaste onto the wet brush.
NOTE
To avoid being sprayed, do not switch on the appliance until it is in your
mouth.
4) Use the on/off switch

to select the desired operating mode.
NOTE
This toothbrush has a 30-second interval timer, so that all four jaw quadrants
can be cleaned evenly.
5) Divide your mouth into four parts (quadrants): upper left, upper right,
lower left and lower right.
6) Start in one quadrant:
Start with the brush head  on your gums, and move the brush upwards/
downwards from the gums to the crown of the tooth.
Continue in this manner on both the inside and the outside of the tooth.
Start again at the gums for each individual tooth.
Do not forget to brush the back of the rear molars.
To clean the chewing surfaces, guide the brush over them with a little
pressure.