Instructions
8
7.5. O Timer
7.6. Automatic mode (Auto Mode)
The unit can be switched
o in 12 steps (0-12 hours)
using the timer.
The speed of the fans
(and thus the air ow) is
automatically controlled
according to the measu-
red air quality.
Each fan stage less redu-
ces the airow by 25%.
(Level 4 = 100%/ Level 3=75%/
Level 2= 50%/ Level 1 =25%)
replaced.
After changing the lter, press the „FILTER
RESET“ key for 3 seconds to reset the counter
to 1500 hours.
8. Filter change
1. switch o the unit, pull out the mains plug
and remove the back cover by hand.
2. remove the used lter; the lter can be
disposed of in the household waste.
3. clean the inner housing with a soft cloth.
4. install the new lter with the blue side facing
outwards.
5. close the lid.
6. the installation is complete.
Note: After changing the lter, press the
„FILTER RESET“ key.
The maximum running time of 1,500 hours of
the replaced lter is thus correctly calculated.
The running time of the lters depends,
among other things, on the load of the air
sucked in and the speed of the fans and is
shown on the display.
9. Safety Instructions
9.1. To prevent damage due to overheating
of the air purier, make sure that both the
air inlet and the air outlet are not covered.
9.2. Do not place the unit next to a heater, as
there is a risk of re or deformation of the
cabinet due to heat.
9.3. Unplug the power cord when cleaning the
machine, replacing the lter or when not
using it for a long period of time.
9.4. Do not move the air purier unless it
has been previously switched o.
9.5. Do not use the unit if the power supply
cable is damaged. In this case contact
your point of sale.
9.6. To prevent the appliance from wobbling or
tilting, ensure that the appliance is placed
on a level and non-slip surface.