New Bright Table of Contents Section 1: Section 2: Section 3: Section 4: Section 5: Section 8 Section 7: Section & Section % Section Hh: Section 11: Table of Contents Component Checklist Removing the Battery Charging the Battery Vehicle Battery Installation Vehicle Features and Functions Transmitter Battery Installation Transmitter Features and Functions Proper Use Precautions and Care Trouble Shooting and Support Cautions
. New Bright Removing Battery This vehicle Is shipped with the battery paid installer in the vehicle for demonstration purposes. This battery is only partially charged and should be fully charged before use: To remove the battery, tir the battery compartment rock 90: degrees as shown below. “Then, slide battery back toward the battery compartment lock: for Instructions ofi charging the battery, see Section 4.
Battery Charging IMPORTANT] The included: 9,6V Lithium fon battery pack is poly PARTIALLY CHARGED prior fo shipment and it is recommended the battery be fully charged before first use. Charging Status Battery Charger Push and Hold Bunion To Remove 9.5V Battery Pack 1. insert ie 8:8V Lithium lon marriageable battery pack securely itd the: charger and push unto lock. Be:sure the Arrows are properly matched {as shown above). 2.
Vehicle Battery Installation ir. Locate and align arrow on battery pack with arrow inside battery compartment, Place battery pack In battery compartment and slide battery forward in direction of arrow. Once in page, turn docking tab to keep battery pack secure.
Yaa Features and Functions Wheat Alignment © Steering Trim) vehicle gills to the refection right during forward riving tha Steering Trim may need 10 be adjusted: The Steering Trim is located on bottom of chassis between the front wheels,
FEE ade Battery Installation Firmly press TAB In the direction of the ARROW and pull back t6 open battery compartment Cover. stall 24AAY batteries as shown, making sure and markings on batteries line up with the and(=) markings in the battery compartment. Replace battery compartment cover, Cover should click when locked in place. Note: When replacing Transmitter batteries: tse alkaline batteries only. Do not mix old and new bakeries.
Transmitter Features and Functions Note: Vehicle has working lights, When driving forward or reverse the lights will turn an, When stopping either in forward of reverse the fights will flash, then turn off. This transmitter is equipped with 2.4GHz technology which allows unto 6 vehicles to be raced at the same time, How to pair your vehicle and transmitter 4, Properly install Batteries into the transmitter. (Section 7) 2. Be certain vehicle OFFEND Switch.
Proper Use be Precautions and Care Switch vehicle OFF Brush areas where when not in: use: dirt gets trapped; Wipes body with a Do not use chemicals soft rag or cloth. or water to clean.
Trouble shooting & Support problem Vehicle-does not move groves slowly. . Make certain there are fresh batteries in ihe transmitter and that they have been installed in the correct position, + Ate the {and markings on the attentive ini the same position a8 the (4) and markings in the Transmitter Battery Compartment? . Ha the Battery Pack been installed In the vehicle? .
AY Bright mmm Cautions JE Dio not leave the toy unattended while charging it: Battery charging should overdone by adults: Charge the toy ona non-flammable surface and keep it away from flammable knifes Turn the charger off when the toy's battery is charged, and always unplug it from the toy. Disconnection AC wall chargers battlefronts while not in use. if the toy has been damaged, immediately stop use, unplug, and safety move the toy away from flammable materials.