User's Manual

HUB Installation Manual 776-91-05-REV-A_HUB_INSTALLATION_MANUAL.docx
THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR
DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN
AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.
5
2. INSTALLATION INSTRUCTIONS
To begin, check the parts available against the equipment list, identifying any missing parts. If all
parts are accounted for, proceed to the instructions below to begin installing the HUB.
Step 1: Identify the Flexible ½ wave center-fed dipole antenna
with articulated knuckle (C). Screw the antenna into the gold
coaxial antenna connector on the front panel of the HUB
assembly (B). Ensure that the antenna is screwed onto the
connector snugly, but take care not to over-tighten the antenna
as it will damage the connector or the HUB assembly front
panel.
Step 2: Identify the USB Cable, Type A to Type B (A). The type-A end of
the cable is smaller and flatter than the type-B end of the cable and will
mate with a standard USB port on a PC. Plug this end into one of the USB
ports on the Personal Computer (PC) (E). Plug the other end (Type-B) into
the mating USB connector on the front panel of the HUB assembly (B).
Type-A
Type-B