User's Manual

IREP Assembly Manual 776-91-03-REV-A.docx

THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR

DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN

AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.

2. ASSEMBLY INSTRUCTIONS

To begin, check the parts available against the equipment list, identifying any missing parts. If all

parts are accounted for, proceed to the instructions below to begin assembling the indoor repeater

(IREP).

Step 1: The inside enclosure (A) should come inside of the outside enclosure (C) as indicated in

the figure below. Place the PCB (F) over the inside enclosure so that the LED’s line up with the

three consecutive holes and that the holes in each corner of the PCB line up over the screw holes

on the enclosure. Insert the enclosure screws (E) into each corner of the PCB attaching the board

to the enclosure.

Step 2: Put the washer on the end of the RF cable (G) with the jack and feed it through the

opening in the enclosure from the inside out. Rotate the nut clockwise around the outside of the

RF jack until it is flush against the enclosure.

Step 1

Step 2