User's Manual

IREP Assembly Manual 776-91-03-REV-A.docx

THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR

DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN

AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.

Step 3: Take the SMA plug end of the RF cable and attach it to the RF port labeled J1 on the PCB

by laying the plug over the port and pressing down. The plug should snap right into place.

Step 4: Attach the SMA Antenna to the RF jack by screwing it in clockwise to the outside of the

enclosure.

Step 5: Insert the Tenergy battery (B) connector into the 3 pin header on the PCB beside the “on”

switch. After doing so, apply a piece of double sided tape (D) to either side of the battery, and

press the battery against the metal shields on the PCB.

Step 3

Step 4

Step 5