Assembly Manual

OREP Assembly Manual 776-91-04-REV-.docx
THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR
DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN
AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.
5
2. ASSEMBLY INSTRUCTION
To begin, check the parts available against the equipment list, identifying any missing parts. If all
parts are accounted for, proceed to the instructions below to begin assembling the outdoor
repeater (OREP).
Step 1: Take the bottom enclosure (C) and place an OREP spacers/washers (I) over each of the
inside screw holes as designated in the figure below. Lay the OREP PCB (B) over the bottom
enclosure, making sure there is a spacer under each corner of the PCB. Insert a tapping screw (D)
into each corner, mounting the PCB to the enclosure.
Step 2: Identify the rubber mat and line the holes up with the elevated screw holes in each corner.
Feed the openings on the rubber mat through the double pegs beside each elevated screw hole.
Step 1
Step 2