Installation Manual

OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx

THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR

DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN

AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.

2. INSTALLATION INSTRUCTIONS

To begin, check the parts available against the equipment list, identifying any missing parts. If all

parts are accounted for, proceed to the instructions below to begin installing the OREP.

Step 1: Identify the Mounting Base-Treated Plywood (I). Place the

plywood on the ground laying flat. Identify the Tripod Base (J), open its

legs until fully extended, and center it on the plywood. Mark the points for

the drill holes with a pencil and set aside

the base. Drill 1/8” holes where they are

marked on the plywood. Identify the

Hardware to attach to OREP Bracket (B).

Push the screws up through the drilled holes from the bottom of the

plywood, and align the tripod base with the screws. Push the screws

through the holes in the tripod base and secure with a washer and nut

(from Hardware to attach to OREP Bracket (B)) on each screw.

Make sure hardware is secure before proceeding to the next step.

Step 2: Place Mast (L) down through the center of the

Tripod Base (J). Tighten screws at the top and center of

the Tripod Base (J) to secure the Mast (L).