Installation Manual

OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx
THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR
DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN
AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.
8
Step 6: Note the OREP bracket has two curved half-moon shaped areas on the back of it. These
areas allow the bracket to seat flushly on the mast. Identify the U-
Bolts, nuts, washers (Q), and while holding the OREP-bracket
assembly on the mast, place one u-bolt around the mast and feed
through the matching holes in the OREP bracket. Secure this u-bolt
with two nuts and two washers. Repeat the process for the other u-
bolt. Ensure both u- bolts are tightened snugly.
Step 7: Take TN-Male to N-Male Pigtail cable (U) and attach to OREP (A) and secure. Take open
end and attach to Light Surge (H) and secure. Take open end Light
Surge (H) and 2
nd
cable (U) and secure together. Take open
end Light Surge (U) and secure to bottom of antenna (M).