User's Manual

OREP Assembly Manual 776-91-04-REV-A.docx

THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR

DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN

AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.

Step 8: Lay one side of the top enclosure over the bottom enclosure, making sure that all of the

wires/cables are tucked inside and that none are folded over as that may cause damage. Slowly

close the enclosures together until the top enclosure is flush against the bottom. The edges should

fit together neatly.

Step 9: Flip the enclosures over so that the bottom enclosure is on top. Insert the 4 enclosure

screws (G) into the screw holes on the bottom enclosure. Screw clockwise to finish assembling the

OREP.

3. FCC NOTIFICATION

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE

CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS

COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE

FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT

MAY CAUSE UNDESIRED OPERATION.

Step 8

Step 9