CA3500, BA3500, CH3500 New Comfort 6 Stage AIR PURIFIER INSTRUCTION MANUAL CAUTION: Read manual carefully for proper installation and operation.
CONTENTS Specifications ...................................................................................................... 2 Features .............................................................................................................. 3 Introduction ......................................................................................................... 4 Applications ......................................................................................................... 5 Installation ...
SPECIFICATIONS Model: Rated Voltage: Power Consumption: Fan Speed (non-grade): Ion Output Air Volume: UV Spectrum: Sound Level (DV): Particle Purifying Rate: Product Size in inches: Gross Weight: Ozone Plates CA3500, BA3500, CH3500 USA-AC 120V/60Hz 40W 1500-3000 RPM ≥5 x 106cm3 (or≥2.5 x 106/cm3) Max 106 CFM(3 m3/min) ≥20ìw/cm2(at 10cm-distance) Low35 Med45 High50 up to 99.97% HEPA W 9 in x D 11 in x H 12 in 14.
WARNING! - Do not operate without proper installation. Doing so may void the warranty. CAUTION! – Cut off the power when performing maintenance. If the fuse is blown and needs to be changed. Fusing current no more than 1.0 Amp. INTRODUCTION New Comfort reproduces the natural environment outdoors. It is not designed to create clean fresh air like the outdoors with its 6 stages of purification. Keeps your air clean and fresh with 6 stages of filtration.
Photo Labs & Salons Day Care Centers Chemical Odors Bowling Alleys & Parlors INSTALLATION 1. Remove unit from shipping carton. 2. Remove all protective materials. 3. Read Owner’s Manual thoroughly prior to installation. 4. Fully insert cord into the power cord receptacle on the back of the unit. 5. Install Ozone and Filters as shown in the steps below.
Determine placement location and plug unit into 120-volt outlet. PLACEMENT In order to maximize the purification function, the unit should be placed as high as possible. Alternately, placing something under the unit bottom, ensuring the front grill is tilted upward will better oxidize and purify the floating bacteria and smog pollutants. A ceiling fan can also aid the unit with air purification. Suggested locations, listed in order of preference: Nearest to the source of the worst pollutant.
SETTINGS AND ADJUSTMENTS 1. Control of the Unit When looking at the front of the unit, the controls for UV, Ionization, Fan Speed are located on the right. The knob on the left controls the Ozone. This allows using the New Comfort as a standard air purifier (no Ozone but pulling air through the 5 stages of filtration) or to use all 6 stages (Ozone included). 2. Ozone Control The Ozone control can turn on, off or adjust ozone function without degrees.
MAINTENANCE Periodic maintenance is required to ensure that the New Comfort operates properly. A severely polluted environment can foul an air purifier plate in as little as four weeks or as long as a year. Shown here are basic maintenance procedures that should be carried out to keep your unit running at top performance. Pre-Filter/HEPA Filter Cleaning: (Turn to page 7 for removal instructions.
REPLACING THE FUSE A fuse holder is located on the back of the unit next to the power cord. To replace or check the fuse: Remove the fuse holder by pressing on the clip and pulling straight out. If the fuse is blown: Replace with the standard replacement fuse. Insert the new fuse into the fuse holder. Press the assembly straight in until it latches. 120 volt models: Fusing current no more than 1.0 Amp. CAUTION! If the fuse holder cap is not installed correctly, the unit will not operate.
Make sure the electrical outlet is capable of providing power to the unit. Check the back cover located at the back of the unit to make sure it is fully installed and snapped into place. If the back cover is not fully installed, a safety switch will cause the unit to not power on. Check to see if the proper fuse is installed and that it is serviceable. Ensure that the fuse cap is completely seated and secured in its receptacle. Be sure the cord is fully plugged into unit. 2.
Warranty Information: If your unit fails to operate properly after performing trouble-shooting, contact your authorized New Comfort dealer you purchased the unit from for further assistance. The New Comfort air purifier comes with a 3-year Factory Warranty that covers the entire unit (except for filters and ozone plates which may need replacing as they get dirty). For warranty assistance contact the company you bought the air purifier from for authorized warranty service.