Use and Care Manual

INSTALLATION

1. Remove unit from shipping carton.

2. Remove all protective materials.

3. Read Owner’s Manual thoroughly prior to installation.

4. Fully insert cord into the power cord receptacle on the back of the unit.

5. Install Ozone and Filters as shown in the steps below.

Installing Ozone Plates and Filters:

Step 1: Make sure the unit is unplugged

before installing or removing any filters or

maintaining the unit in any way to prevent

electric shock.

Step 2: Push two latches down on back cover.

Step 3: Remove HEPA & Active carbon filter

by pulling out the white ribbon on the top.

Step 4: Insert the 2 Ozone plates found in the

small brown box. For maximum performance,

Ozone plates may need to be washed in warm

water. Always allow them to properly dry

before installing.

Step 5: Reinstall all filters in the same order

they were removed and reattach back cover.

Determine placement location and plug unit

into 120-volt outlet.